• If you are citizen of an European Union member nation, you may not use this service unless you are at least 16 years old.

  • Whenever you search in PBworks or on the Web, Dokkio Sidebar (from the makers of PBworks) will run the same search in your Drive, Dropbox, OneDrive, Gmail, Slack, and browsed web pages. Now you can find what you're looking for wherever it lives. Try Dokkio Sidebar for free.


Injection Molding Books

Page history last edited by PBworks 16 years, 8 months ago

Date: 08:45 PM GMT, 05/10/2005

From: Alfred H Raschdorf Jr


I've gotten a lot of mileage out of Robert A. Malloy's

"Plastic Part Design for Injection Molding, An

Introduction", published by Hanser.


It's got Mold Filling, Gating, Weld Lines, Warpage,

Ejection, Rapid Prototyping, Press Fits, Snap Fits,

Ultrasonic Welding and much much more. I laughed, I cried.


For the economical minded or the mind that wants the

knowledge pronto, GE plastics puts out a decent design

guide for injection molding (it is not as thorough, but a

good starter):


(You have to complete a free registration.)



--- Fred Bould wrote:

> can anyone recommend a good reference book on injection

> molding.

> covering issues like gating, ejection, etc. ?

> --

> fred bould


> bould design

> 228 verbena drive

> east palo alto, ca 94303


> tel: 650.965.4509

> fax: 650.328 1141

> email: fred@bould.com

> http://www.bould.com

Comments (0)

You don't have permission to comment on this page.